Lubrifilm Sprint MS

Lubrifilm Metal ACTEX

1731,00

₽

Additive to motor oil

Application:
Designed for restoration without disassembly by metallization of parts of 2-stroke engines. The shelf life of the product is 1,000 - 1,500 km.

Instructions for use:
1. Warm up the engine to operating temperature so that the product gets on all surfaces subject to wear.
2. Unscrew the spark plug, set the piston to the top dead center and inject the prescribed amount of Lubrifilm with the applicator along the piston diameter.
3. Move the piston to the bottom dead center and repeat the operation according to point 2.
4. Without the spark plug installed, turn the engine for approximately 15 seconds so that the product gets on the surfaces to be treated.
5. Install and tighten the spark plug and start the engine. The white smoke that appears will disappear immediately. Over the course of 15 minutes, gradually increase the engine load to its full power. After this operation, you can drive normally - the application of the product is complete.
6. Repeat the application every 1000-1500 km.

Dosage:
Cylinder volume / Dosage
Up to 50 cm3 2x1 cm3
Up to 90 cm3 2x1.25 cm3
Up to 125 cm3 2x1.50 cm3
Up to 250 cm3 2x1.75 cm3
Up to 500 cm3 2x2 cm3
Up to 750 cm3 2x2.5 cm3
Above 750 cm3 2x2.5 cm3

Note: 1 cm3 2 = 1 ml
For engines with several cylinders, add the specified amount to each cylinder.

Action:
Restores compression to the value corresponding to the compression of a new engine.

Package volume: 50 ml

Аpplication: For motor vehicles